Electrical Insurance Claims in San Jose, CA
Homeowner's insurance typically covers sudden electrical damage from lightning strikes, power surges, and accidental shorts. Wear-and-tear, code upgrades, and wiring remediation (knob-and-tube, aluminum) are excluded. In CA, some insurers refuse coverage for homes with Federal Pacific or Zinsco panels until they are replaced.
Typically Covered
- ✓ Lightning strike damage
- ✓ Sudden power surge damage
- ✓ Fire damage from covered electrical failure
- ✓ Emergency repair after covered peril
Typically NOT Covered
- ✗ Wear-and-tear on wiring or panels
- ✗ Code upgrades required after a claim
- ✗ Aluminum wiring remediation
- ✗ Recalled panel replacement (Federal Pacific, Zinsco)
Before You File a Claim
Document all damage with photos and video immediately. Contact your insurer to open a claim and get a claim number before starting any repairs. Request that your contractor be present during the adjuster's inspection so scope and pricing can be confirmed on the spot.
Permits & Safety
Electrical Permits in San Jose, CA
California requires a permit for virtually all electrical work beyond simple like-for-like replacements. San Jose inspections are conducted by the local building department. An unpermitted electrical installation can void your homeowner's insurance, create liability in a sale, and — more importantly — create a fire hazard if work was not inspected.
⚠️Typically Requires a Permit
- ●Panel upgrade or subpanel installation (any amperage)
- ●EV charger installation (240V / Level 2)
- ●New circuit installation (any purpose)
- ●Service entrance upgrade (100A → 200A or higher)
- ●Rewiring any portion of the home
- ●Adding outlets in a kitchen, bathroom, garage, or outdoors
- ●Generator or battery storage system interconnection
✓Usually No Permit Required
- ●Replacing a like-for-like outlet or switch (same circuit, same location)
- ●Replacing a ceiling fan or light fixture on an existing circuit
- ●Swapping a breaker for the same amperage (no panel work)
- ●Installing a dimmer switch on an existing circuit
When in doubt, ask your contractor — pulling an unnecessary permit is cheaper than fixing unpermitted work later.
What to Expect at an Electrical Inspection
- 1
Permit pulled before work starts
Your licensed electrician pulls the permit from the local building department before any work begins. In California, only a C-10 licensed electrician (or homeowner for owner-occupied residential) can pull an electrical permit.
- 2
Rough inspection (if applicable)
For new circuits or panel work, a rough inspection happens before walls are closed. The inspector checks wire gauge, breaker sizing, grounding, and conduit runs.
- 3
Final inspection
The inspector verifies the completed work: panel labeling, GFCI protection in wet areas, AFCI protection on required circuits, proper bonding, and EV charger amperage. They sign off on the permit card.
- 4
Permit closed
Once final inspection passes, the permit is closed. Keep a copy — it's proof of compliant work for insurance claims and home sales.
Verify Your Electrician's License (California)
In California, all electrical work requiring a permit must be performed by a C-10 Electrical Contractor licensed by the Contractors State License Board (CSLB). Always verify before hiring.
- •Look up any contractor's license number, status, and bond at cslb.ca.gov
- •Check that their C-10 (Electrical) classification is active and not suspended
- •Confirm their workers' comp insurance is current — CSLB shows this
- •A contractor who refuses to provide their license number is a red flag
⚠️ Never skip the permit to save money
Unpermitted electrical work is one of the top reasons homeowner's insurance denies fire claims. If an inspector finds unpermitted work during a sale, you may have to tear out walls to re-inspect. The permit fee is small — the consequences of skipping it are not.